How to Replace Torsion Springs
Replacing garage door springs is probably the most difficult, not to mention a dangerous job to do. Which is why it is advisable to hire a garage door repair company to do it for you. However, if you are unable to do this, then you need to carefully follow these steps in order to familiarize yourself on how garage door springs and their components work, and how to properly handle the springs to prevent serious injury to yourself.
To install a new spring, the eye bolt needs to be secured to the track’s hangar. Once this has been secured, the other end of the spring has to be attached to the front pulley with a U-shaped clip around it. This clip is then secured to the pulley using a sturdy nut and bolt. The next thing is to secure this bolt on to the track flag. This can be done from the inside the door. The pulley has to be attached to the outside of the track and then secured.
Once this is done, put the cable back to its original position, this is done by pulling the spring tightly and stretching it. Make sure you align the hole-plate and tie the cable on to the plate. Then secure this to the plate’s open end by using an S-hook. Pull this cable tight and tie to secure it into place. This entire procedure is then repeated on the other spring. The most important safety tip you must remember when is it comes to garage door spring replacement is to replace them at once to prevent any further damage.
You must take every safety precaution because changing springs is still dangerous when not handled with care. It is vital you remember to keep the garage door completely open and secured before performing this job. Remember, this is a job is best left to the professionals so do not hesitate to contact A Pro Garage Door Repair Service at Stockton, CA on (209) 226-4714 today to speak to our garage door company if you have any questions or concerns regarding spring door replacement.